What do I do if I constantly hear a busy signal on my phone?

Article author
Cogeco support
  • Updated

There are several issues which may result in your phone service giving you a busy signal. Your service may be disrupted due to an outage, the number you are calling may be unavailable or the line may be legitimately busy.

There are several possible causes to this problem. To troubleshoot:

  • Make sure that all of your phones are hung up properly.
  • Check if the lights on your modem are on.
  • If you cannot see any lights:

Check the power supply. The black cable at the back of the modem must be plugged into an electrical outlet. You can also try a different outlet.

If all of the modem’s lights are on:

Make sure a telephone wire is plugged into the TEL1 port on the back of the modem and into a phone jack. If you subscribe to two phone lines, make sure that the two telephone wires are properly plugged into their respective phone jacks.

If all of the modem’s lights are on and the TEL1 light is flashing:

Place all wireless phones back on their base and check if you hear a dial tone. If not, unplug all of your phones from their wall jacks and test them one at a time. To do this, plug one phone back into the wall jack and check for a dial tone. If there is still no dial tone, unplug this phone and try with another phone.

If only  some of the modem’s lights are on:

Try to resynchronize the modem. Use a straightened paper clip to push in the reset or reboot button at the back of the modem (in a small black hole). Hold the button for 10 seconds, then wait a few minutes before checking for a dial tone. 

If these solutions do not fix the problem, please contact our Technical Support team. It might be a network or cable modem outage. If so, Cogeco will take steps to restore the service as quickly as possible.

Was this article helpful?

8 out of 52 found this helpful


We are currently working on our new and improved support section. We have a lot to share with you and wanted to say thank you for your patience as we fully migrate over.




Please sign in to leave a comment.