What do I do if the picture and sound don’t go together?

Article author
Cogeco support
  • Updated

This is usually caused with a HDMI connection from the receiver to the TV. Please follow the steps below to resolve the situation.

  • Check if the problem is present on one or many channels. If the problem is present on one channel only, please refer to the Reported Outages page to check if there is an outage on this channel.
  • If there are many channels affected, turn off the receiver by pressing CBL and PWR, then wait 15 seconds. Turn the receiver back on. The sound should now go together.
  • Otherwise, unplug the HDMI cable behind the receiver or the TV, and then wait 15 seconds. Plug the HDMI cable back in. The sound should now go together.

If the problem persists, contact the Technical Support for more assistance.

Was this article helpful?

5 out of 7 found this helpful

WELCOME TO OUR COGECO SUPPORT

We are currently working on our new and improved support section. We have a lot to share with you and wanted to say thank you for your patience as we fully migrate over.

SEE ALL ARTICLES ON COGECO.CA

Comments

0 comments

Please sign in to leave a comment.